Effective and selective aerobic oxidation of primary and secondary alcohols using CoFe2O4@HT@Imine‐CuII and TEMPO in the air atmosphere

In this study, we present a versatile and easy procedure for modifying a cobalt ferrite nanoparticle step by step. A new nanocatalyst was prepared via Cu^II immobilized onto CoFe₂O₄@HT@Imine. The catalyst was fully characterized by Fourier‐transform infrared (FT‐IR), energy‐dispersive X‐ray spectroscopy (EDX), field emission scanning electron microscopy (FE‐SEM), X‐ray diffraction (XRD), and vibrating sample magnetometer (VSM) analyses. The current procedure as a green protocol offers benefits including a simple operational method, an excellent yield of products, mild reaction conditions, minimum chemical wastes, and short reaction times. Without any significant reduction in the catalytic performance, up to five recyclability cycles of the catalyst were obtained. The optimization results suggest that the best condition in the oxidation of benzyl alcohol derivatives is 0.003 g of the CoFe₂O₄@HT@Imine‐Cu^II catalyst, TEMPO, at 70°C under solvent‐free condition and air.     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

A sensitive and efficient method for trace analysis of some phenolic compounds using simultaneous derivatization and air‐assisted liquid–liquid microextraction from human urine and plasma samples followed by gas chromatography–nitrogen phosphorous detection

In present study, a simultaneous derivatization and air‐assisted liquid–liquid microextraction method combined with gas chromatography–nitrogen phosphorous detection has been developed for the determination of some phenolic compounds in biological samples. The analytes are derivatized and extracted simultaneously by a fast reaction with 1‐flouro‐2,4‐dinitrobenzene under mild conditions. Under optimal conditions low limits of detection in the range of 0.05–0.34 ng mL^?1 are achievable. The obtained extraction recoveries are between 84 and 97% and the relative standard deviations are less than 7.2% for intraday (n = 6) and interday (n = 4) precisions. The proposed method was demonstrated to be a simple and efficient method for the analysis of phenols in biological samples. Copyright © 2015 John Wiley & Sons, Ltd.     

Phosphoric-Acid Retention in High-Temperature Proton-Exchange Membranes

Great efforts have been conducted to develop high temperature proton exchange membrane fuel cell (HT-PEMFC) due to its features of enhanced electrocatalyst reactivity, simplified hydrothermal management system and high CO tolerance of catalysts, and remarkable progress has been achieved. However, the easy leaching of phosphoric acid (PA) from the membranes during operation limits its commercial scale-up in complicated environments. This concept here mainly focuses on the recent developments for mitigation of PA loss in PEMs. The probable mechanisms of PA loss are proposed. The approaches to improve PA retention for example via introduction of phosphonic acid by covalent bond, using ion-pairs interaction and siphoning effect, and blending with inorganic nanoparticles are described in detail. Among these strategies, the siphoning effect from the intrinsic microporous PEMs is the most efficient and enables the cell to operate flexibly within a broad temperature range. Therefore, this concept may provide new ideas for the scientists to retain PA, to improve the cell performance and expand the potential applications of PA doped PEMs at elevated humidity and wide temperature range.     

基于显示连通贝叶斯网络的机场塔台地震易损性分析

将基于性能的多维易损性分析方法,结合显示连通贝叶斯网络,应用于机场塔台的多维易损性分析。考虑地震激励的不确定性,通过非线性时程分析获得结构响应数据;将塔台结构分为三个层次,每个层次按包含的层数分为相应的子层次。根据功能特性确定子层次的评价指标和极限状态,建立服从多元对数正态分布的概率地震需求模型;考虑各种极限状态之间的相关性,建立极限状态方程,确定失效域,通过蒙特卡洛法求得构件的超越概率;建立塔台结构的显示连通贝叶斯网络模型,利用层次分析法获得中间节点的条件概率表,利用MATLAB进行贝叶斯网络的推理计算,实现从单一层次的易损性到整体易损性的推理。     

微波瑞利散射法测定空气电火花激波等离子体射流的时变电子密度

大气压空气电火花激波等离子体射流的电子密度在亚微秒时间尺度上瞬变,其电子密度的测定很难.基于微波瑞利散射原理,本文测量了空气电火花冲击波流注放电等离子体射流的时变电子密度.实验结果表明:测量系统的标定参数A为1.04 × 105 V·Ω·m–2;空气流注放电等离子体射流的电子密度与等离子体射流的半径和长度有关,结合高速放电影像展示的等离子体射流的等效半径和等效长度,测定的电子密度在1020 m–3的量级,且随时间先快速增长至峰值再成指数衰减.此外,本文还探讨了等离子体射流的不同等效尺度对测定结果的影响;分析结果表明,采用时变等效半径和时变等效长度的计算结果最有效,且第1个快速波峰是由光电离的电离波导致的.     

Introducing voids around the interlayer of AlN by high temperature annealing

Introducing voids into AlN layer at a certain height using a simple method is meaningful but challenging. In this work, the AlN/sapphire template with AlN interlayer structure was designed and grown by metal-organic chemical vapor deposition. Then, the AlN template was annealed at 1700 ℃ for an hour to introduce the voids. It was found that voids were formed in the AlN layer after high-temperature annealing and they were mainly distributed around the AlN interlayer. Meanwhile, the dislocation density of the AlN template decreased from 5.26×10⁹ cm^-2 to 5.10×10⁸ cm^-2. This work provides a possible method to introduce voids into AlN layer at a designated height, which will benefit the design of AlN-based devices.     

One-step synthesis of VB2 powder by epoxy-assisted borothermal reduction of V2O5

Vanadium diboride was directly synthesized by borothermal reduction of V₂O₅ with the addition of epoxy resin as a reducing agent for the low-temperature reduction of vanadium(V) to vanadium(IV), which leads to the gradual removal of oxygen by the formation of CO gas. The slow rate of gas release prevents destruction of green body, which usually occurs during conventional borothermal reduction. This makes it possible to directly obtain VB₂ powder with an average particle size of 200–300 nm without need to prepare intermediate lower vanadium oxides.     

顶空气相色谱法测定工作场所空气中的乙酸乙酯

采用顶空气相色谱法测定工作场所空气中的乙酸乙酯。气态乙酸乙酯用活性炭管吸附,二氯甲烷解吸,顶空进样,HP–FFAP毛细管柱分离,FID检测器测定,峰面积定量。乙酸乙酯的质量浓度在1.76~880.0μg/m L范围内与色谱峰面积呈良好的线性,相关系数r=0.999 4。不同浓度样品批内测定结果的相对标准偏差为1.34%~3.61%(n=7),批间测定结果的相对标准偏差为1.04%~4.78%(n=7),加标回收率为91.02%~100.29%,方法检出限为0.32μg/m L,解吸效率为91.28%~95.19%。对于100 mg活性炭,乙酸乙酯的穿透容大于2.2 mg,当其浓度在17.6~17 600 mg/m3时,采样效率为91.23%~97.40%,常温下可以保存10 d。该方法各项指标均达到《工作场所空气中有毒物质检测方法研制规范》的要求,适用于工作场所空气中乙酸乙酯的现场监测。     

Recycling Application of Li–MnO2 Batteries as Rechargeable Lithium–Air Batteries

The ever‐increasing consumption of a huge quantity of lithium batteries, for example, Li–MnO₂ cells, raises critical concern about their recycling. We demonstrate herein that decayed Li–MnO₂ cells can be further utilized as rechargeable lithium–air cells with admitted oxygen. We further investigated the effects of lithiated manganese dioxide on the electrocatalytic properties of oxygen‐reduction and oxygen‐evolution reactions (ORR/OER). The catalytic activity was found to be correlated with the composition of Li_xMnO₂ electrodes (0<x<1) generated in situ in aprotic Li–MnO₂ cells owing to tuning of the Mn valence and electronic structure. In particular, modestly lithiated Li_0.50MnO₂ exhibited superior performance with enhanced round‐trip efficiency (ca. 76 %), high cycling ability (190 cycles), and high discharge capacity (10 823 mA h g_carbon^?1). The results indicate that the use of depleted Li–MnO₂ batteries can be prolonged by their application as rechargeable lithium–air batteries.